All Start/Stop Switch Panel; Power Trim And Tilt Switch On Digital Electronic Control; Power Trim And Tilt Switch On Bottom Cowling - Yamaha F225 Owner's Manual

pressing the Start/Stop button. For twin type,
it is possible to start or turn off individual en-
gine. The indicator for the corresponding en-
gine will come on.
PORT:Port side engine

STBD:Starboard side engine

1
2
1. Indicator
2. Start/Stop button
EMU41631

All Start/Stop switch panel

The Start/Stop button allows all engines to
start or turn off.
1
1. All Start/Stop button
EMU35153
Power trim and tilt switch on digital
electronic control
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch "
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position. For instructions
on using the power trim and tilt switch, see
pages 64 and 66.
ZMU07174
EMU26155
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on
the side of the bottom cowling. Pushing the
switch "
and then tilts it up. Pushing the switch "
(down) tilts the outboard motor down and
trims it down. When the switch is released,
the outboard motor will stop in its current po-
sition.
For instructions on using the power trim and
tilt switch, see page 66.
EWM01031
ZMU07176
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
falling overboard and could distract the
operator, increasing the risk of collision
with another boat or an obstacle.
" (up) trims the
Components
" (down) tilts the outboard
UP
DN
" (up) trims the outboard motor up,
WARNING
ZMU05822
"
32