Table of Contents
Advertisement
202 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Turning LaneSense ON Or OFF
The default status of LaneSense is "OFF".
The LaneSense button is located on the center stack
below the Uconnect® display.
LaneSense Button Location
To turn the LaneSense system ON, push the LaneSense
button to turn the system ON (LED turns off). A "Lane
Sense On" message is shown in the DID.
To turn the LaneSense system OFF, push the LaneSense
button once to turn the system OFF (LED turns on).
NOTE: The LaneSense system will retain the last system
state ON or OFF from the last ignition cycle when the
ignition is changed to the ON/RUN position.
LaneSense Warning Message
The LaneSense system will indicate the current lane drift
condition through the Driver Information Display (DID).
7.0 Driver Information Display (DID) Screen — If
Equipped
When the LaneSense system is ON; the lane lines are gray
when both of the lane boundaries have not been detected
and the LaneSense indicator is solid white.
Advertisement
Chapters
Table of Contents
