Chevrolet spark 2017 Owner's Manual page 84

raise the head restraint
and route the tether
under the head restraint
and in between the head
restraint posts.
If the rear outboard
seating position you are
using has an adjustable
head restraint and you
are using a dual tether,
raise the head restraint
and route the tether
under the head restraint
and around the head
restraint posts.
3. Before placing a child in the
child restraint, make sure it is
securely held in place. To
check, grasp the child restraint
at the LATCH path and attempt
to move it side to side and
back and forth. There should
be no more than 2.5 cm (1 in) of
movement for proper
installation.
Head Restraint Removal and
Reinstallation
The rear outboard head restraints
can be removed if they interfere with
the proper installation of the child
restraint, see Securing a Child
Restraint Designed for the LATCH
System previously in this section.
Store the head restraints in a secure
place.
To remove the head restraint:
1. Partially fold the seatback
forward. See Rear Seats 0 51
for more information.
Seats and Restraints
2. Press both buttons on the head
restraint posts at the same time
and pull up on the head
restraint.
3. Store the head restraints in a
secure place.
4. When the child restraint is
removed, reinstall the head
restraint before the seating
position is used.
Warning
With head restraints that are not
installed and adjusted properly,
there is a greater chance that
(Continued)
83