Chevrolet spark 2017 Owner's Manual page 53

52 Seats and Restraints
Warning
A safety belt that is improperly
routed, not properly attached,
or twisted will not provide the
protection needed in a crash. The
person wearing the belt could be
seriously injured. After raising the
rear seatback, always check to be
sure that the safety belts are
properly routed and attached, and
are not twisted.
Warning
With head restraints that are not
installed and adjusted properly,
there is a greater chance that
occupants will suffer a neck/
spinal injury in a crash. Do not
drive until the head restraints for
all occupants are installed and
adjusted properly.
To return the rear seats to the
normal seating position:
1. Move the safety belt out of the
way by putting the safety belts
into the belt guide on the trim.
The safety belt should not
cross the seatback locking
mechanism when raising the
seatback.
2. Lift the seatback up slightly and
reinstall the head restraint. See
Head Restraint Removal and
Reinstallation under Lower
Anchors and Tethers for
Children (LATCH System) 0 77.
3. Push the seatback rearward all
the way to lock it in place.
4. Push and pull the top of the
seatback to be sure it is locked
into position.
5. Return the seat cushion to its
original position and push
down on the front part of the
seat cushion until it latches.
6. Remove the safety belt from
the belt guide on the trim.
7. Repeat Steps 1 6 for the other
seatback and seat cushion,
if necessary.
If added cargo space is not needed,
the seatbacks should be kept in the
upright, locked position.