Table of Contents
Advertisement
Monogram
36" Built-In French-door Bottom-freezer
®
FLUSH INSET INSTALLATION 3/4" PANELS
26 3/16"
(66.5)
Flush inset depth
20 15/16"
(53.2)
Depth to cleat
Finished cleats
85"
(215.9)
W
SIDE VIEW
ANTI-TIP BRACKET
81 1/2"
(207.0)
SIDE VIEW INSTALLED
WITH ANTI-TIP BRACKET
5 1/4"
(13.3)
3/4" Panel
3/4"
(1.9)
Width of side cleats
4 1/16"
(11.0)
85"
(215.9)
3 1/2"
(8.9)
Use two
additional hole
locations at end
of brackets
FLUSH INSTALLATION
ZIP360NH
FRONT VIEW OF CUTOUT
WITH ANTI-TIP BRACKET
TOP VIEW
Case
Finished cleats
Case Trim
Door
1/2"
39"
(99.1) Flush inset width
37 1/2"
(95.3)
Width between cleats
A
6"
ELEC.
(15.2)
10"
(25.4)
75 1/2"
(191.8 )
From floor
to bottom
of electrical
7"
7"
(17.8)
(17.8)
3 1/2"
B
(8.9)
WATER
FRONT VIEW
C
L
Bracket
mounted
into vertical
wall studs
centered
within the
cutout
Ensure holes
selected are
centered on
the studs
Wall
Studs
FLUSH INSET INSTALLATION
NOTES
A Mounting the junction box in this
(1.3)
location will also allow for front
accessibility through access panel.
B Water supply area
WARNING:
The refrigerator is top heavy and must
be secured to prevent the possibility of
tipping forward. Failure to do so may
result in death or serious injury.
The information below is for cabinet
design only. When installing the anti-
tip system you must use the product
installation instructions.
The information below applies to all
area
installation constructions:
• A wall bracket, bolts and toggles will
be supplied with the unit.
• The bolts will be used to attach bracket
to wall in 4 locations. Two of the
locations must penetrate the center
of the wall studs.
• The toggles are used for stability in
drywall and when metal studs are
encountered. Lag bolts are used in
wood studs.
• In installation opening, measure
81 1/2" from floor and draw a
horizontal line.
• Locate and mark the wall studs on
horizontal line. Verify at least two
studs have their centerlines within the
center 32.5" of installation opening to
ensure 2 wall studs are penetrated.
• The bracket will be centered left to
right in opening with bottom of
bracket on the horizontal line.
• When unit is placed in opening, the
bracket tabs will align with openings
in back of the unit. The unit will be
secured to the bracket using supplied
"L" bolts.
See Installation Instructions for
detailed instructions.
Product Specification Revised 3/15
ZIP360NH
Advertisement
Table of Contents
