Step 2 Install Anti-Tip Bracket; Step 3 Connect Water Line; Step 4 Connect Power - Monogram 30" Built-InBottom-Freezer, 2-DrawerRefrigerator Design And Installation Manual

STEP 2 INSTALL ANTI-TIP BRACKET

• Inside Top Face of bracket should be installed at 80".
"Slot" in bracket should to be placed in center of install
Space (Typically 15")
• Mark (within slots, placement) stud and anchor positions
on brackets.
80"
Slot
•Secure bracket using combination of studs & anchors.
•At least 1 stud must be engaged.However, please engage
as many studs as possible within the enclosure. A mininum
of three fasteners should be used for proper installation.
Installation Instructions
14

STEP 3 CONNECT WATER LINE

• Position appliance in front of enclosure.
• Locate and bring tubing to the front of the cabinet.
• Turn the water on to flush debris from line. Run about
a quart of water through tubing into a bucket; then
shut off water.
If needed cut the tubing to the proper length so it can
be attached to the water valve.
Copper Tubing:
• Slip a 1/4" nut and ferrule over both ends
of the copper tubing. Insert tube into the union fitting
on the unit and tighten nut to union.
• Turn on the water to check for leaks.
GE SmartConnect™ Tubing:
• Insert the end of the tubing into the refrigerator
connection. Tighten the compression nut until it is just
hand-tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.

STEP 4 CONNECT POWER

• Plug the power cord into the socket.
• Check to make sure power to refrigerator is on by
opening the ice drawer (FF door will be banded shut)
to see if interior lights are on.
• The temperature controls are preset at 37°F for the
fresh food section and 0°F in both the freezer drawer
and customizable drawer.
• Allow 24 hours to stabilize before making
adjustments.
Water
Line Hole