Orion XTREME 600.4 Owner's Manual page 39

Distorted output Internal crossover not set properly
for speakers
Speakers are blown
Poor bass response Speakers wired with wrong polarity
causing cancellation at low frequency
Crossover set incorrectly
Impedance load at amplifier is too low
Battery fuse Short in power wire or incorrect
blowing power connections.
Fuse used is smaller than recommended
Too much current being drawn
Amplifier fuse Too much current being drawn
blowing
Fuse used is smaller than recommended
Impedance load at amplifier too low
Speaker is blown with shorted outputs
Readjust crossovers. Refer to the Internal Crossover section of this
manual for detailed instructions.
Check system with know working speakers and fix or replace as needed.
Check speaker polarity and fix as needed.
Reset crossovers. Refer to the Internal Crossover section of this manual
for detailed instructions.
Check speaker impedance load, if below 2 stereo or 4 mono
rewire speakers to achieve a higher impedance.
Check power and ground connections and fix or repair as needed.
Replace with proper fuse size.
Check speaker impedance load, if below 2 stereo or 4 mono
rewire speakers to achieve a high impedance.
Check power and ground connections and fix or repair as needed.
Check speaker impedance load, if below 2 stereo or 4 mono rewire
speakers to achieve a high impedance and replace with recommended
size fuse.
Check power and ground connections and fix or repair as needed.
Replace with proper fuse size.
Check speaker impedance load. If below 2 stereo or 4 mono, rewire
speakers to achieve a higher impedance.
Check system with known working speakers and fix or replace as needed
page 39