Dimplex DF2550-EU Owner's Manual page 9

Fireplace Installation
the end.
③
Loosen the screw securing
the junction box cover and
remove the cover.
④
take the cables out from the
junction box, loosen the terminal
block and remove the cord set
(Figure 2).
⑤
Route the power supply wire
through the knockout on supplied
Figure 2
alternative junction box cover
and secure with a wire clamp (not
supplied) (Figure 3).
⑥
Connect the live from the
unit to the live from power supply
(Figure 3).
⑦
Connect the neutral from the
unit to the neutral wire from power
supply (Figure 3).
Figure 3
⑧
Connect the green wire
(ground) from the unit to the
green wire from power supply
(Figure 3).
⑨
Place all connectors inside
the unit and secure the junction
box cover to unit. Ensure that the
cable clamp grips only the jacket
of service cable.
CAUTION:
air circulation beneath the
fireplace insert is provided by
two (2) rubber feet.
Do not install the fireplace
insert directly on carpet or
similar surfaces which may
restrict air circulation.
If installing the fireplace in a
carpeted area, place a one-
Clearance for
9