Denon DRR-M33 Operating Instructions Manual page 11

(2) Auto power on function (when connected to the RCD-M33/M35DAB)
2 When the system is set to the standby mode, you can start the playback of tape simply by pressing the
PLAY button on the system remote control unit.
RC-999 (System remote control unit)
1
(3) Auto function selection (when connected to the RCD-M33/M35DAB)
2 Use this function to switch the function to "TAPE" and start playing the tape simply by pressing a single
button.
1
DRR-M33 (this unit)
RC-999 (System remote control unit)
1
Press the PLAY button.
• System's power turn on and the function of
CD receiver automatically switches to
"TAPE".
And then, the TAPE starts
1
playing.
The auto power on
function does not work
(RC-999)
even when the DRR-
M33's PLAY button is pressed.
When a TAPE is loaded with the DRR-M33 in
the standby mode, cassette deck can be started
simply by pressing the DRR-M33's PLAY button.
Press the PLAY button while a unit
other than the DRR-M33 (this unit)
is playing.
• Playback on the currently playing
(DRR-M33)
1
unit stops.
At the same time, the CD
receiver's function
switches to "TAPE" and
the cassette deck playing.
(RC-999)
(4) CD synchronized recording (when connected to the RCD-M33/M35DAB)
2 Use this function to record CDs easily.
3
RCD-M33/M35DAB (CD receiver)
1
2
DRR-M33 (this unit)
7 6 4 5
RC-999 (System remote control unit)
1
Turn on the power of
1
the CD receiver.
(RCD-M33/M35DAB) (RC-999)
Load the cassette tape onto which
2
you want to record into the DRR-
M33's cassette holder.
(DRR-M33)
3 Load the CD into the CD receiver.
(RCD-M33/M35DAB)
ENGLISH
Set the DRR-M33's play direction
4
indicator ( 0 or 1 ) to the direction
in which you want to record.
(DRR-M33)
Set the reverse mode.
5
Refer to page 7.
(DRR-M33)
6
Set the Dolby NR mode.
(DRR-M33)
Press the DRR-M33's CD SRS
button.
• Recording of the CD starts
automatically.
(DRR-M33)
Once all the tracks on the CD
have been played, the CD receiver is
automatically set to the stop mode, a 5-
second blank space is created on the tape
in the DRR-M33 and the stop mode is set.
7
Please check that the CD receiver has
completed the TOC reading operation of the
CD before pressing the CD SRS button.
The CD SRS button does not work while the
TOC is being read on the CD receiver.
The DRR-M33 and the CD receiver are also
automatically set to the stop mode if the
cassette tape is fully recorded before
playback of the CD has ended.
To stop recording in the middle, press the
(stop) button on the DRR-M33 or CD receiver to
stop CD playback. CD synchro recording continues
if any other buttons are operated.
NOTE:
• The CD synchronized recording function does
not work when the CD receiver is set to the
program play mode.
2
11