Lubricating The Drive Chain - Yamaha BANSHEE 350 YFZ350Z Owner's Manual

specified limits.
[ECB00542]
TIP
There are alignment marks on each side of the
swingarm and on the wheel hubs. Use them to
check for proper wheel axle alignment.
1 2
(b)
(a)
1. Drive chain slack adjusting bolt
2. Locknut
3. Alignment marks
4. Tighten the locknuts and the axle holding nuts
to the specified torques.
3
8-43
Tightening torques:
Locknut:
16 Nm (1.6 m·kgf, 11 ft·lbf)
Axle holding nut (upper):
120 Nm (12.0 m·kgf, 85 ft·lbf)
Axle holding nut (lower):
60 Nm (6.0 m·kgf, 43 ft·lbf)
EBU24882

Lubricating the drive chain

The drive chain must be cleaned and lubricated at
the intervals specified in the periodic maintenance
and lubrication chart, otherwise it will quickly wear
out, especially when riding in dusty or wet areas.
Service the drive chain as follows.
ECB00561
NOTICE
The drive chain must be lubricated after wash-
ing the ATV or riding in the rain or wet areas.
1. Clean the drive chain with kerosene and a
small soft brush. NOTICE: To prevent dam-
aging the O-rings, do not clean the drive
chain with steam cleaners, high-pressure
washers or inappropriate solvents.
1
2
3
4
5
6
7
8
9
10
11
[ECB00571]