Error - Navien NCB-24LSWE Service Manual

Testing method
Fault Possible causes
110E Intake air supply /
Exhaust blockage exhaust flow error
Condensate drain Condensate drain

error

Deformed or
blocked flue
Defective air
supply/exhaust
Exhaust gas
flue
enters the air
supply pipe
5.2.12 Error 205
Error conditions and checklist
Error
E205
Heat exchanger
If an error (open: -10°C or lower) in the heat exchanger input temperature sensor is detected, the system
output
displays '205E' on the front panel. If this occurs, the boiler shuts down.
temperature
sensor open
1. Check if the heat exchanger output temperature sensor connector is wet due to any reason,
2. Replace the defective heat exchanger output temperature sensor.
Checklist
3. Check the circulation pump's operating status and the flow rate in the space heating lines.
4. Test the voltage at the PCB to verify the correct voltage at the pump. If there is no voltage, bleed the
104 NCB Service Manual
1. If 110E occurs intermittently during ignition or combustion, compare the
standard speed with the current speed at min/max combustion. If the current
speed is higher than normal, check the following:

Air supply / exhaust pipes for blockage.

Blocked condensate drain

Broken or blocked air pressure sensor hose.
2. Replace the old PCB with the latest version.
Exhaust air is blocked due to condensate drain faults.
 Check if the condensate hose or the siphon is frozen.
 Check if the condensate hose is kinked.
error
 Remove the bottom of the trap and verify it is not blocked.
1. Check the exterior of the flue for damage and obstructions.
2. Check if rainwater has accumulated in vertically installed sections of the air
intake.
If exhaust gas enters the air supply pipe, combustion faults may cause E110.
 Check the installation of the flue.
including leakage.
air from the system before resetting the unit. If the error condition persists, replace the pump.
Testing method
Description
Version 1.0