Replacing A Rear Turn Signal Light Bulb - Yamaha XMAX YP250RA Owner's Manual

Periodic maintenance and adjustment
Replacing a rear turn signal
light bulb
1. Place the scooter on the center-
stand.
2. Open the seat. (See page 3-20.)
3. Remove the rear storage com-
partment by removing the bolts.
4. Remove the socket (together with
the turn signal light bulb) by turn-
ing it counterclockwise.
ZAUM1040
1. Storage compartment
2. Bolt
3. Rubber cap
5. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
1
ZAUM1038
1. Turn signal light bulb socket
6. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
EAUM3062
3
2
1
2
ZAUM1039
1. Turn signal light bulb
2. Turn signal light bulb socket
7. Install the socket (together with
the bulb) by turning it clockwise.
8. Place the rear storage compart-
ment in the original position and
install the bolts.
9. Close the seat.
6-32
1
6