Handlebar Switches - Yamaha XMAX YP250RA Owner's Manual

Instrument and control functions

Handlebar switches

Left
3
1. Pass switch "
2. Dimmer switch "
3. Turn signal switch "
4. Horn switch "
Right
1
2
3
1. "TRIP/INFO" switch
2. Hazard switch "
3. Start switch "
Pass switch "
Press this switch to flash the headlight.
Dimmer switch "
Set this switch to "
beam and to "
EAU1234H
"
/ "
/ "
"
"
"
EAU12351
"
EAU12401
/ "
" for the high
" for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Start switch " "
With the sidestand up, push this switch
while applying the front or rear brake to
crank the engine with the starter. See
page 5-2 for starting instructions prior
to starting the engine.
The engine trouble warning light will
come on when the key is turned to
"ON" and the start switch is pushed,
but this does not indicate a malfunc-
tion.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
3-14
EAU12461
/ "
". When
EAU12501
"
EAU12722
EAU41701
EAU12735
" posi-