Yamaha XMAX YP250RA Owner's Manual page 55

Periodic maintenance and adjustment
Panel C
To remove the panel
1. Remove the quick fastener, and
then pull the under cowling off as
shown.
TIP
The quick fastener is removed by
pushing the center pin in with a screw-
driver, and then pulling the fastener
out.
1
2
ZAUM1042
1. Cowling
2. Quick fastener (after removal)
2. Remove the cowling screws, and
then pull it off.
2
1
ZAUM1043
1. Screw
2. Cowling
3. Remove the battery bracket bolts,
and then pull it off.
4. Remove the battery bracket and
panel assembly by pulling it off as
shown.
1
6-8
3
2
ZAUM1045
1. Panel C
2. Bracket
3. Bolt
To install the panel
1. Place the battery bracket and
panel assembly in the original po-
sition, and then install the bolts.
2. Place the cowling in the original
position, and then install the
screws.
3. Place the under cowling in the
original position, and then install
the quick fastener.
TIP
To install the quick fastener, push the
center pin out so that it will protrude
from the fastener head, insert the fas-
tener into the under cowling, and then
push the protruding pin in until it is
flush with the fastener head.
1
3
6