D-Link DSL-7850U User Manual page 56

In this section we can configure the advanced wireless settings.
Band: This parameter will display the current wireless band being configured.
Channel: Automatically set or select a channel option.
Auto Channel Timer: Enter the auto channel timer value used here.
802.11n/EWC: Select this 802.11n/EWC option used here. Options to choose from
are Auto and Disabled.
Bandwidth: Select between 20MHz or Auto 20/40MHz
Control Sideband: Select between Upper or Lower
802.11n Rate: Select the 802.11n rate used here.
802.11n Protection: Select this 802.11n protection option used here. Options to
choose from are Auto and Off.
RIFS Advertisement: Select the RIFS advertisement option used here. Options to choose from are Auto and Off.
OBSS Co-Existence: Select the OBSS co-existence state here. Options to choose
from are Enable and Disable.
Support 802.11n Client Only: Select the support for 802.11n clients only option
used here. Options to choose from are On and Off.
RX Chain Power Save: Select the RX chain power save state here. Options to
choose from are Enable or Disable.
Power Save status: This parameter will display the power save status.
RX Chain Power Save Quiet Time: Enter the RX chain power save quiet time
value used here. This option becomes available after the RX Chain Power
Save was enabled.
RX Chain Power Save PPS: Enter the RX chain power save PPS value used here. This option becomes available after the RX Chain Power Save was enabled.
54g™ Rate: Select the 54g™ rate value used here. This option becomes available after the 802.11n/EWC option was disabled.
Multicast Rate: Select the multicast rate used here.
錯誤! 使用 錯誤 使用 [常用 常用] 索引標籤將 索引標籤將 Heading 1 套用到您想要在此處顯示的文字
錯誤 錯誤 使用 使用 常用 常用 索引標籤將 索引標籤將
D-Link DSL-7850U VDSL2 Router User Manual
套用到您想要在此處顯示的文字。 。 。 。
套用到您想要在此處顯示的文字 套用到您想要在此處顯示的文字 Page 56