Replacing The Pump-Drive Belt - Toro 74568TE Operator's Manual

G015595
Figure 66
1. 16.5 cm (6.5 inches) from
hook to hook
2. Spring
3. Spring-loaded idler
4. Ratchet
5. Square hole for ratchet
6. Nut
g017890
1. 16.5 cm (6.5 inches) from
hook to hook
2. Spring
3. Spring-loaded idler

Replacing the Pump-Drive Belt

Service Interval: Every 100 hours—Check the pump-drive
belt.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the mower-deck belt.
4. Tilt the machine; refer to Raising the Mower for Access
(page 29).
5. Remove the shoulder bolt, the nut, and the washer
from the engine deck and connected spring (Figure 68).
47
Figure 67
4. Ratchet
5. Square hole for ratchet
6. Nut