Operating The Power Take Off (Pto) - Toro 74225 Operator's Manual

6. Turn ignition key to start. When engines starts, release
key.
Important
Do not engage starter for more than 10
seconds at a time. If engine fails to start allow 30 second
cool-down period between attempts. Failure to follow
these instructions can burn out starter motor.
7. After the engine starts, move the choke to off
(Fig. 17). If the engine stalls or hesitates, move the
choke back to on for a few seconds. Then move the
throttle lever to desired setting. Repeat this as
required.
2
1
m–4201
Figure 16
1. PTO—On
2. PTO—Off
1
2
m–2720
Figure 18
1. Throttle—Fast
2. Throttle—Slow
Stopping the Engine
1. Move the throttle lever to slow (Fig. 18).
2. Turn the ignition key to off (Fig. 19).
Note: If the engine has been working hard or is hot, let it
idle for a minute before turning the ignition key off. This
helps cool the engine before it is stopped. In an
emergency, the engine may be stopped by turning the
ignition key to off.
3. Pull wire off spark plug(s) to prevent possibility of
4. Close fuel shut off valve, on front panel before
Important
before transporting or storing machine, as fuel leakage
may occur. Set parking brake before transporting.
2
Operating the Power Take Off
(PTO)
1
The power take off (PTO) switch engages and disengages
power to the electric clutch.
m–2719
Figure 17
Engaging the PTO
1. Choke—On
1. While seated in the seat, release pressure on the
2. Choke—Off
2. Place throttle to the fast position.
3. Pull out on the power take off (PTO) switch to engage
1
2
3
Figure 19
1. Off
2. Run
3. Start
1. PTO—Off
Disengaging the PTO
1. To disengage push the PTO switch to the off position
21
someone accidentally starting the machine before
transporting or storing machine.
transporting or storing machine.
Make sure fuel shut off valve is closed
traction control levers and place in neutral.
(Fig. 20).
1
Figure 20
(Fig. 20).
2
m–4201
2. PTO—On