Setup; Loose Parts; Installing The Drive Wheels; Checking The Tire Pressure - Toro 74225 Operator's Manual

Setup

Loose Parts

Note: Use the chart below to verify all parts have been shipped.
Description
Rear Wheels
Retaining rod
Bolt, 5/16-18 x 1 in.
Locknut, 5/16
Control lever, right
Control lever, left
Bolt, 3/8-1 x 1 in.
Spring washer, 3/8 in.
Filter Minder
Adapter
Air Filter
Hose Clamp
Key
Operator's Manual
Engine Operator's Manual
Parts Catalog
Registration Card

Installing the Drive Wheels

1. Uncrate mower.
2. Remove wheel nuts from rear wheel hubs.
3. Align holes. Mount drive wheels with the valve stem
to the outside of the traction unit.
4. Secure using wheel nuts provided. Torque to 95 ft-lbs
(128 N M).
Important
Make sure that wheel nuts are torqued to
95ft–lbs (128 N M).

Checking the Tire Pressure

Check the air pressure in the front and rear tires (Fig. 2).
Pressure: 13 psi (90 kPa)
Qty. Use
2 Installing the drive wheels
1
1

Installing the seat retaining rod

1
1
1
Installing the motion control levers
4
4
1
Installing the filter minder
1
1
Installing the air cleaner
1
2
1 Read before operating machine
1 Read before operating machine
1
1 Fill out and return to Toro
1. Valve stem
Installing the Seat Retaining
Rod
1. Tilt seat up. Remove the locknut (5/16 in.) from bolt
attaching seat retaining rod to seat frame (Fig. 3).
15
1
m–1872
Figure 2