Making Alternate Cutting Unit Adjustments; Adding Rear Ballast; Installing Ce Decals; Reading The Manuals And Storing Additional Parts - Toro 03806 Operator's Manual

4
Making Alternate Cutting Unit
Adjustments
No Parts Required
Procedure
The factory sets the tractor appropriately for most
fairway mowing applications. Several adjustments for
fine-tuning the machine for particular applications are
included in the Cutting Unit Maintenance section as
follows:
• Adjusting the cutting unit lowering rate
Adjusts the speed at which the cutting units lower.
• Adjusting the lifted height of the outer front cutting
units
Adjusts the turnaround height of the outer front
cutting units to provide greater clearance on
contoured fairways.
• Adjusting the travel of the front three cutting units
Adjusts the downward travel of the front three
cutting units to allow for highly contoured fairways.
5

Adding Rear Ballast

Parts needed for this procedure:
100lb Calcium chloride (obtain separately)
Rear weight kit, part number 104–1478 (obtain
1
separately)
Procedure
To comply with CEN standard EN 836:1997, ISO
standard 5395:1990, and the ANSI B71.4-2004
Standard, add 100 lb (45 kg) of calcium chloride
ballast to the rear wheels and install the rear weight kit
(Part Number 104-1478).
Important: If a puncture occurs in a tire with
calcium chloride, remove unit from turf area as
quickly as possible. To prevent possible damage to
turf, immediately soak affected area with water.
6

Installing CE Decals

Parts needed for this procedure:
4 CE decals
2 CE certificate
Procedure
If you will be using the machine in a CE country, install
the supplied CE decals over the corresponding ANSI
decals on the product. Store the CE certificates in a safe
location.
7
Reading the Manuals and
Storing Additional Parts
Parts needed for this procedure:
1 Operator's Manual
1 Engine Operator's Manual
1 Parts Catalog
1 Operator Training Material
1 Diagnostic ACE display overlay
1 Ignition keys on ring
1 Hood lock key
2 Screw
2 Wing nut
Procedure
1. Read the manuals.
2. View the Operator Training Material.
3. The diagnostic ACE display overlay is for diagnosing
machine malfunctions. Store it in a safe location.
21