Programming Steam Portion; Programming Tea Portion - Capresso C3000 User Manual

• Coffee button you selected (ex. "1 small cup").
• Then it will DISPLAY Please Wait.
• When the actual brewing starts the
show the following two messages alternately:
Enough Coffee? and Press Key
• When you have enough coffee in your cup press the
button. The machine stops brewing and the display shows:
OK? P ·········· II ··········
options:
• Option 1: When you press the
save the amount of coffee you just programmed and the
DISPLAY
will show PRESS KEY. You can now program
another coffee button.
• Option 2: If you press the
increase or decrease the amount of water slightly. The double
vertical bars in the display will move to the right or the left.
Put a cup underneath the coffee spout. Now press the coffee
button again. The machine will grind and brew again and
then it will stop automatically. The
OK?...Press the button to confirm.
P
When you are finished programming the water quantities for
your coffee buttons press the
COFFEE READY or press the
programming section.

15.4 Programming Steam Portion

If you want the same amount of frothed milk you can program
how long the frother should dispense steam. This is particularly
practical when using the machine in an office or commercial
19.
DISPLAY will
.
P
+
. At this time you have two
button, the machine will
P
+
or buttons you can now
DISPLAY will show again
button to go back to
N
+
button to go to the next
environment. The advantage is that the frothing will stop
automatically after the programming frothing time has elapsed.
At the time of programming, the machine will not froth. It will
simply store the time (3 to 250 seconds). Test the actual
frothing amount (see chapter 14e and 14c). You can always go
P back to programming and decrease or increase the frothing
time until the desired result is reached.
• STEAM PORTION.
DISPLAY
• Press the P
• DISPLAY PORTION /....20 SEC.
• By pressing the
seconds (3-250 sec.)
• Press the
P
• DISPLAY STEAM PORTION
+
• Press the
or press the
N

15.5 Programming Tea Portion

You can program a certain amount of hot water. You can use
this feature for adding a certain amount of hot water to your
coffee drink (ex. cafe americano) or to use it for a quick cup of
tea.
• DISPLAY TEA PORTION.
• Place a cup under the hot water spout (Fig.8a or 8b).
• Press the
P
• DISPLAY OPEN TAP. Turn the selector switch to the water
symbol (Fig.3,L). Hot water will flow into your cup. The
button.
+
or buttons you can program time in
button.
button to go to the next programming section
DISPLAY
button to return to
button .
COFFEE READY .