Setup - Graco GX series Operation, Parts

Setup

Setup
When unpacking sprayer for the first time or
after long term storage perform setup
procedure.
1. Connect Graco airless hose to fluid
outlet. Use wrench to tighten securely.
ti27122a
2. Connect other end of hose to gun.
3. Use wrenches to tighten securely. If
hose is already connected, make sure
connections are tight.
4. Engage trigger lock.
12
5. Remove tip guard. Do not lose the seal.
ti25197a
6. Turn Pressure Control Knob all the way
left (counter-clockwise) to minimum
pressure.
7. When unpacking sprayer for the first
time remove packaging materials from
inlet strainer. After long term storage
check inlet strainer for clogs and debris.
ti25199a
Strain the Paint
Previously opened paint may contain dried
paint or other debris. To avoid priming prob-
lems and spray tip clogs it is recommended
to strain the paint before using. Paint strain-
ers are available where paint is sold. Stretch
a paint strainer over a clean pail and pour
the paint through the strainer to capture any
dried paint and debris before spraying.
ti24931a
ti27123a
ti26894a
3A3212C