Miele CVA 6800 Operating And Installation Instructions page 78

Problem solving guide
Message
F73 or
Check the brew unit
F227, F228, F229, F230
F233
78
Possible cause and remedy
The brew unit cannot be positioned correctly, or it is
dirty and the coffee cannot be processed.
 Check whether you can remove the brew unit (see
"Cleaning and care - Brew unit").
 Clean the brew unit if it can be removed (see
"Cleaning and care – Brew unit").
 Push the coffee ejector of the brew unit into the
correct position (see diagram).
 Push the waste container and the water container
back in the machine. Do not insert the brew unit.
Close the door and switch the machine on with the
On/Off  sensor.
This will initialise the brew unit motor and put it back
into the start position.
 When
Insert the brew unit
open the door and refit all parts in the machine.
Close the door.
If the brew unit cannot be removed:
 Switch the machine off with the On/Off  sensor.
Wait for approx. 2 minutes before switching it back
on again.
There is a fault with the automatic spout adjustment.
 Confirm the message with
Automatic spout adjustment during drink preparation
is deactivated as long as the appliance remains
switched on. You can continue to prepare drinks.
appears in the display,
.
OK