Table of Contents
Advertisement
Familiarize
yourself with these home maintenance
tasks as proper use and care of your vacuum
will ensure
continued
cleaning
effectiveness.
Any other servicing
should be done by an authorized
service
representative.
If appliance
is not working
as it should,
has been dropped,
damaged,
left outdoors,
or dropped
into water,
return it to a service center
prior to continuing
use.
DIRT CUP:
When to Empty
4.1 Empty the dirt cup before the dirt cup reaches
the max line (A). Place the vacuum in the upright
3osition before removing the dirt cup.
,& WARNING A
To reduce the risk of personal injury - Unplug
before cleaning or servicing.
Do not use
vacuum without dirt cup or filters in place.
Very fine materials, such as face powder or
cornstarch, may seal the filter and cause a
reduction in performance. When using the
vacuum for this type of dust, empty the cup and
clean the filters often.
DIRT CUP: How
to
Empty
4.2 Press dirt cup release button and pivot cup out.
4.3 Hold dirt cup over trash receptacle, push dirt cup
door release lever (A) to open dirt cup door (B).
Close dirt cup door (B). Press firmly to secure.
4.4 Place bottom of dirt cup into vacuum body
first. Pivot dirt cup into vacuum. Press down on the
dirt cup release button to secure into place.
I f F-::
_-t
,i,
i,--_r
FILTERS: When to Clean
To maintain optimal performance, filters should be
cleaned every two months under normal use.
A WARNING A
To reduce the risk of personal injury - Unplug
before cleaning
or servicing.
Do not use
vacuum without dirt cup or filters in place.
RinsableFilter: How to Clean
Remove dirt cup as described in Fig. 4.2.
4.5 Twist the dirt cup lid to open.
4.6 Pull tab to remove rinsable filter.
Rinse with water for two minutes or until water runs
clear. Then squeeze out excess water. Allow 24
hours for filter to dry completely.
Replace filter, tab side out.
Close lid securely by twisting dirt cup lid until it clicks
as shown in Fig. 4.5.
Replace dirt cup as described in Fig 4.4.
• IMPORTANT •
Allow filter to dry completely before replacing.
Dry filter on edge so air circulates on both sides
of filter. This may take up to 24 hours.
Advertisement
Table of Contents
