Pushing The Machine By Hand - Toro 74200 Operator's Manual

Pushing the Machine by Hand

IMPORTANT: Always push the machine by
hand. Never tow the machine because
hydraulic damage may occur.
To Push the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to "OFF" to stop the engine.
2. Rotate the by-pass valves counterclockwise 1
turn to push. This allows hydraulic fluid to
by-pass the pump enabling the wheels to turn
(Fig. 13).
IMPORTANT: Rotate by-pass valve a
maximum of 2 turns so the valve does not
come out of the body causing fluid to run out.
To Operate the Machine
1. Turn the by-pass valves in to operate (Fig. 13).
Note: The machine will not drive unless
by-pass valves are turned in.
Figure 13
1. By-pass valve
1
E
Operation
23