1215 Lcd Module - Lenovo ThinkPad X1 Hardware Maintenance Manual

Attention: When installing the antenna assembly, route the cables as shown in the following illustration.
Ensure that the cables are not twisted or subject to any tension. Tension could cause the cables to be
damaged by cable guides.
a WiGig antenna

1215 LCD module

To replace the LCD module, do the following:
1. Disable the built-in battery. See "Disabling the built-in battery" on page 50.
2. Remove the SIM card, SD card, and Base Module. See "Removing the SIM card, SD card, and Base
Module" on page 50.
3. Remove the following FRUs, then you will have the LCD module.
• "1020 Back cover assembly" on page 53
• "1030 Coin-cell battery" on page 58
• "1040 Think LED light" on page 59
• "1050 NFC card, NFC-card cable, and NFC antenna assembly" on page 60
• "1060 Wireless-WAN card" on page 61
• "1070 M.2 solid-state drive and solid-state-drive mylar" on page 63
• "1080 Touch controller card cable" on page 65
• "1090 Infrared camera card and infrared camera cable" on page 66
• "1110 Speaker assembly" on page 68
• "1120 Mini DisplayPort bracket" on page 69
• "1130 USB-connector bracket" on page 70
• "1140 POGO card and POGO-card cable" on page 71
• "1150 LCD cable" on page 73
• "1160 Built-in battery" on page 74
• "1170 Camera cable, camera card, front-facing camera module, and rear-facing camera module"
on page 76
• "1180 Audio card and audio-card cable" on page 78
86
ThinkPad X1 Tablet Hardware Maintenance Manual
a