Installing The Outer Rails To The Rack - Bosch DIVAR IP 6000 (2U) Quick Installation Manual

DIVAR IP 6000 (2U)
To install the inner rails:
1.
2.
3.
4.
4.3.3

Installing the outer rails to the rack

Outer rails attach to the rack and hold the chassis in place. The outer rails for the chassis
extend between 30 inches and 33 inches.
To install the outer rails to the rack:
1.
2.
3.
4.
Locking Tabs
Both chassis rails have a locking tab, which serves two functions. The first is to lock the
system into place when installed and pushed fully into the rack, which is its normal position.
Secondly, these tabs also lock the system in place when fully extended from the rack. This
prevents the system from coming completely out of the rack when you pull it out for servicing.
Bosch Sicherheitssysteme GmbH
2
Place the inner rail extensions on the side of the chassis aligning the hooks of the chassis
with the rail extension holes. Make sure the extension faces "outward" just like the pre-
attached inner rail.
Slide the extension toward the front of the chassis.
Secure the chassis with 2 screws as illustrated.
Repeat steps 1-3 for the other inner rail extension.
1
2
Secure the back end of the outer rail to the rack, using the screws provided.
Press the button where the two outer rails are joined to retract the smaller outer rail.
Hang the hooks of the rails onto the rack holes and if desired, use screws to secure the
front of the outer rail onto the rack.
Repeat steps 1-3 for the remaining outer rail.
Quick Installation Guide
3
1
3
Rack installation | en 17
2016.03 | V2 | DOC