Installation Keep this instruction manual in a safe place for measured according to the worktop, must not future reference. Should the appliance be sold, exceed 2°. transferred or moved, make sure the instruction manual accompanies the washing machine to inform Levelling your appliance correctly will provide it with the new owner as to its operation and features.
Connecting the drain hose Do not use extensions or multiple sockets. Connect the drain hose, The power supply cable must never be bent or without bending it, to a dangerously compressed. draining duct or a wall drain situated between The power supply cable must only be replaced by 65 and 100 cm from an authorised serviceman.
Washing machine description Control panel FUNCTION Buttons Leds ON-OFF/ DOOR ON-OFF LOCK Button PROGRAMME Knob Detergent dispenser START/RESET Button TEMPERATURE Knob SPIN SPEED Knob Detergent dispenser: to add detergent and fabric TEMPERATURE knob: to set the temperature or softener (see page 8). the cold wash cycle (see page 7).
Leds The LEDS provide important information. Cycle phase under way: This is what they can tell you: During the wash cycle, the LEDs gradually illuminate on to indicate the cycle phase under way: Delay set: If the Delay Timer function has been enabled (see Prewash page.
Starting and Programmes Briefly: starting a programme 6. Add the detergent and any fabric softener (see page 8). 1. Switch the washing machine on by pressing button 7. Start he programme by pressing the START/RESET All the LEDS will light up for a few seconds and button.
Personalisations Setting the temperature Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 6). The temperature can be lowered, or even set to a cold wash ( ). Setting the spin speed Turn the SPIN SPEED knob to set the spin speed for the programme selected. The maximum spin speeds for each programme are as follows: Programmes Maximum spin speed...
Detergents and laundry Detergent dispenser The use of extra compartment 4 excludes the possibility of using the pre-wash cycle. In addition, Good washing results also depend on the correct the bleach cycle cannot be run with programmes 7 dose of detergent: adding too much detergent won't (Silk) and Daily (see page 6).
Precautions and advice The washing machine was designed and built in The crossed out "wheeled bin" symbol on the compliance with the applicable international safety product reminds you of your obligation, that when regulations. The following information is provided for you dispose of the appliance it must be separately your safety and should consequently be read collected.
Care and maintenance Cutting off the water or electricity Cleaning the pump supply The washing machine is fitted with a self-cleaning Turn off the water tap after every wash. This will pump that does not require any maintenance. limit the wear of your appliance's water system Sometimes, small items (such as coins or buttons) and also prevent leaks.
Troubleshooting Your washing machine could fail to work. Before calling for Assistance (see page 12), make sure the problem can't easily be solved by consulting the following list. Possible causes/Solution: Problem The appliance is not plugged into the socket, or not enough to The washing machine won't make contact.
Service Before calling for Assistance: Check whether you can solve the problem on your own (see page 11); Restart the programme to check whether the problem has been solved; If this is not the case, contact an authorised Technical Service Centre on the telephone number provided on the guarantee certificate.