Installing The Unit - Kenwood DDX9716BTS Instruction Manual

CONNECTION/INSTALLATION
❏ Supplied accessories for installation
1 Wiring harness × 1
2 Trim plate × 1
3 Extraction keys × 2
4 USB extension cable (1.0 m) × 1
5 GPS antenna (3.5 m) × 1
6 Metal plate × 1
7 Microphone (3 m) × 1
❏ Installation procedure
1
To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Take Connector B on the wiring harness
and connect it to the speaker connector in
your vehicle.
5
Take Connector A on the wiring harness
and connect it to the external power
connector in your vehicle.
6
Connect the wiring harness connector to
the unit.
7
Install the unit in your car.
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (e.g., the sound may skip).
8
Reconnect the " battery.
9
Configure <Initial SETUP>. (Page 4)

Installing the unit

❏ Installing the unit
"
• Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
❏ Installing the trim plate
Attach the trim plate (2).
2
ENGLISH 69