Installation Notes:
• To install the rear wheel, reverse the
removal procedure.
• Make sure that the lug (8) on the
swingarm (7) is located in the slot (6) in
the brake panel.
• Tighten the axle nut to the specified
torque:
88 N·m (9.0 kgf·m, 65 Ibf·ft)
• Adjust the drive chain.
When
installing
the wheel, carefully fit the
brake disc between the brake pads to
avoid
damaging the
pads.
After installing the wheel, apply the brake
several times and then
check
if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not rotate
freely.
CD
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper
assembly.
Improper assembly may lead to loss of
braking capacity.
(8)
(6)
Slot
(8) Lug
(7)
Swingarm
127
I