Using The Wg Flat Adhesive Mount O-Cm1531 - Ricoh WG-M1 Operating Manual

Hide thumbs Also See for WG-M1:
Table of Contents

Advertisement

Using the WG Flat Adhesive Mount O-CM1531

This accessory included in the package fixes our digital camera on a flat surface.
Please read the instructions below carefully for safe use.
Warning
Do not install this product in vehicles in a way which might hinder driving
operations or cause accidents resulting from dropping the product. Do not
operate the camera while driving.
Caution
Always observe the following cautions. Otherwise, your camera may fall off
and result in injuries, damages or submerging.
1. Make sure to install the camera onto the appurtenant camera platform
2. Make sure to install the mount in an intended object securely.
3. Tighten the nut securely so that it will not loosen.
If not followed, could result in injuries, damages or submerging.
Precautions When Using This Product
Do not disassemble or modify this product.
Make sure to use our genuine repair parts for replacement.
Do not leave this product sitting in direct sunlight or high humidity.
This product set up with a camera will sink if dropped in water. Be careful and prevent its falling
by using a gear such as a fall protection strap (commercially available) when using this product
on a ship etc.
Optional repair parts are available for this product :
WG Repair Parts 1 O-CM1474 (Double-sided adhesive tape)
WG Repair Parts 2 O-CM1475 (Nut)
securely.
87

Advertisement

Table of Contents
loading

Table of Contents