Ribbon And Gap/Black Mark Sensor Calibration - AMT Datasouth Fastmark M5e User Manual

Ribbon and Gap/Black Mark sensor calibration

Gap/black mark sensor sensitivity should be calibrated at the following
conditions:
1.
A brand new printer
2.
Change label stock
3.
Printer initialization
Please follow the steps below to calibrate the ribbon and gap/black mark sensor:
1.
Turn OFF the power switch
2.
Hold on the button then turn on the power switch
3.
Release the button when the LED becomes
do during the 5 blinks)
 The ribbon sensor and gap/black mark sensor sensitivity will be
calibrated.
 The LED color will change in the following order:

Green
(5 blinks)
Note:
Please select gap or black mark sensor using Diagnostic Tool or by
GAP or BLINE command prior to calibrate the sensor.

amber red (5 blinks)
 
red/amber (5 blinks)
Release button
- 28 -
red and blinking. (Any red will
 
amber (5 blinks)
solid green

green (5 blinks) green/amber