Positioning The Seat; Unlatching The Seat; Using The Drive Wheel Release Valves - Toro Z Master G3 Operator's Manual

• Allows increased ground speed in heavy conditions.
• This position is similar to the benefits of the Toro
SFS mower.
Figure 33

Positioning the Seat

The seat can move forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
To adjust, move the lever sideways to unlock seat
(Figure 34).
G008962
Figure 34

Unlatching the Seat

1. Seat latch
Using the Drive Wheel Release
Valves
Hands may become entangled in the rotating
drive components below the engine deck, which
could result in serious injury.
Stop the engine, remove the key, and allow all
moving parts to stop before accessing the drive
wheel release valves.
The engine and hydraulic drive units can
become very hot. Touching a hot engine or
hydraulic drive units can cause severe burns.
Allow the engine and hydraulic drive units to
cool completely before accessing the drive
wheel release valves.
The drive wheel release valves are located in the back of
each hydraulic drive unit, under the seat.
Note: Make sure the release valves are in the fully
horizontal position when operating the machine or
severe damage to the hydraulic system can occur.
1. Disengage the PTO (blade control switch) and turn
the ignition key to off. Move the levers to neutral
locked position and apply parking brake. Remove
the key.
2. Rotate the release valve levers vertically to push the
machine. This allows hydraulic oil to by-pass the
pump enabling the wheels to turn (Figure 36).
3. Disengage parking brake before pushing.
25
Figure 35
2. Seat