Adjusting The Motion Control Damper; Adjusting The Motion Control Neutral Lock Pivot - Toro Z Master G3 Operator's Manual

Adjusting the Motion Control
Damper
The top damper mounting bolt can be adjusted to
obtain a more desired motion control lever resistance.
See Figure 79 for mounting options.
Figure 79
RH Motion Control Shown
1. Torque the lock nut to 200 in-lb (16.7 ft-lb). Bolt must
protrude past end of locknut after torque.
2. Least resistance (softest feel)
3. Damper
4. Medium resistance (medium feel)
5. Most resistance (firmest feel)
Adjusting the Motion Control
Neutral Lock Pivot
The flanged nut can be adjusted to obtain a more desired
motion control lever resistance when moving it to the
neutral lock position. See Figure 80 for adjustment
options.
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired feel.
For more resistance, tighten the flanged nut.
For less resistance, loosen the flanged nut
3. Tighten jam nut.
1. Flanged nut
51
Figure 80
2. Jam nut