Temperature Recorder (Option) - Panasonic MDF-594C Operating Instructions Manual

TEMPERATURE RECORDER (OPTION)

The figure below shows the description of a temperature recorder.
Warning indicator
Door
Feeding of recording paper
1. Open the door and let down the lever of the penholder; the pen point is apart from the recording paper.
(Fig. 1)
2. Pull the cartridge out of the mounted position. (Fig. 2)
3. Set a new recording paper in place on the rear bottom of the cartridge. Set the hole on the recording
paper in the cog of the recording paper driving assembly and feed the recording paper in the direction of
the arrow by driving the cog wheel.
4. Set the recording paper according to the mark of day and time. (Fig. 3)
5. When mounting, lay down the cartridge first, and push into the mounting position with the groove set a
the projection on the position.
6. Set up the cartridge and settle in position.
Replacement of battery
Replace the dry cell once a year as follows:
1. Put up the pen holder first, then pull out cartridge from the
mounted position.
2. Reset the battery chamber cover with wire, on the bottom left
side, and take out the battery.
3. Set a new battery by turning its anode to this side.
4. Shut the cover after exchanging battery. Mount the cartridge
as before and lay down the penholder lever.
Note :
This temperature recorder is designed for the manganese
battery and the alkaline battery.
Do not use a rechargeable battery because the initial voltage of
such battery is low. The rechargeable battery may cause the
malfunction of recorder or shorten the battery life significantly.
Fig. 1
Recording indicator
Pen holder lever
Cartridge
Fig. 2
26
Time Temperature
Fig. 3
Battery