References; Useful Notes; Troubleshooting - Oppo DV-983H User Manual

REFERENCES

Useful Notes

•
In order to prolong the service life of your DVD player, it is recommended to wait at least 30
seconds before you turn it on again after switching it off.
•
Remove disc and turn power off after operation.
•
Some functions of the player may not be applicable to certain discs.
•
Some discs with special features may not be fully supported by the player. This is not a
malfunction of the unit.
•
In case of player malfunctioning, please turn it off, wait for 30 seconds and turn it back on. If the
problem still exists, please follow the troubleshooting instructions or contact an OPPO service
center.

Troubleshooting

Use this chart to help you solve operational problems. If there are any problems that you cannot solve,
please contact your OPPO service center.
Symptom Possible Cause
No sound Audio cable is not properly
connected
Muting is activated
SACD is played and the audio
connection is coaxial or optical
digital audio
No picture Video cable is not properly
connected
TV input is not correctly
selected
"Audio-Only" mode engaged
Video output format is not
support by the TV
Video system is not supported
by the TV
No color Video system is not supported
by the TV
Saturation set too low
Loose or damaged S-Video
cable
Incorrect video output port
Incorrect color Incorrect color space setting
Incorrect component video
cable connection
Picture rolling Video system is not supported
by the TV
"No Disc" error No disc or incompatible disc
loaded in player
Disc not properly loaded
Condensation on the Laser
pick-up head
Remote control Remote control is out of range
failure
Low battery
Solution
Check audio cable, and then reconnect if necessary.
Press the MUTE button to cancel the mute.
This is not supported due to copyright restrictions of
SACD. Please use the analog or HDMI audio output.
Check video cable, reconnect if necessary.
Select the input to which the DVD player is connected.
Check the "A. Only" display on the front panel, and
press the AUDIO ONLY button to cancel this mode.
When playback is completely stopped, repeatedly
press the HDMI button until the picture appears.
When playback is completely stopped, press the P/N
button or set the correct TV Type.
When playback is completely stopped, press the P/N
button or set the correct TV Type
Check the saturation setting on TV and DVD player.
If using S-Video output, check that the cable is
properly plugged in and not damaged.
If using composite video output, check that the cable is
not incorrectly plugged into the component video jack.
If using HDMI for video output, check the color space
setting on the TV and DVD player.
If using component video output, check the three
component video cables to make sure the signals
match on both ends
When playback is completely stopped, press the P/N
button or set the correct TV Type
Eject disc and check.
Eject disc and make sure the label side is facing up
and the record side is facing down.
Turn on the player, eject the disc and leave the player
on for about an hour.
Use the remote control within the effective range.
Replace the batteries.
60
Reference
Page
9 - 16
28
15
9 - 10
44
21
31, 58
31, 58
55
9
9
55
11
31, 58
26
26
2
8
8