Table of Contents
Advertisement
4.ADVANCED FUNCTIONS
4
Press [BOX NUMBER] to display the entry screen. Key in the box number(s) (a
maximum of 20 digits), and then press [OK].
If you want to set a password (a maximum of 20 digits), key in the password in the same way as the box
number.
If the box number or password is incorrect, an error message is displayed and you are unable to proceed.
5
Specify the recipient to be registered, and then press [OK].
P.27 "Specifying the recipient"
Specify the recipient from the address book because this cannot be done with direct dialing.
6
The confirmation screen for sending a relay transmission report is displayed. If you
want to send the report, select [YES]. If not, select [NO].
By default, the relay transmission end terminal report is sent when a communication error occurs. On the
ADMIN menu, you can make setting so that the report can be sent automatically. For details of the operation,
refer to the MFP Management Guide.
4 ADVANCED FUNCTIONS
Mailbox Transmission
67
Advertisement
Table of Contents
