Before Using This Unit - Onkyo T-4711 Instruction Manual

Before using this unit

A FM75
FREQ. STEP
USA
Please insert the batteries into the remote control according to the illustration.
1
Remote control sensor
Remote control
4
REMOTE
OUTPUT
ANTENNA CONTROL
B AM
L
FM STEREO / AM TUNER
MODEL NO.
FREQ. STEP RATING: AC120/220-230V
R
USA OTHER 2-1,NISSHIN-CHO,NEYAGAWA-SHI,OSAKA,
JAPAN MADE IN JAPAN
WARNING AVIS
RISK OF ELECTRIC SHOCK RISQUE DE CHOC ELECTRIQUE
DO NOT OPEN NE PAS OUVRIR
OTHER
-
2
+
-
30˚
30˚
T-4711
VOLTAGE SELECTOR
50/60Hz 12W
220-230V 120V
AC OUTLETS
SWITCHED
TOTAL 500W MAX.
VOLTAGE SELECTOR
220-230V 120V
3
+
-
T-4711
approx. 5m
Setting the voltage selector
and Tuning step frequency
(Worldwide models only)
Voltage selector
1. Determine the proper voltage for your area:
220 – 230 V or 120 V.
2. If the preset voltage is not correct for your
area, insert a screwdriver into the groove
in the switch. Slide the switch all the way
to the right (120 V) or to the left (220 –
230 V), whichever is appropriate.
Tuning step frequency
Wooldwide models are equipped with a
switch that controls the AM (9 kHz/10 kHz)
and FM (50 kHz/200 kHz) bands tuning
steps. Please set this switch to match the tun-
ing step frequency in your area.
U.S.A. : AM 10 kHz, FM 200 kHz
(25 kHz, Fine mode)
Other areas : AM 9 kHz, FM 50 kHz
(25 kHz, Fine mode)
Inserting the remote control
batteries
Remove the battery compartment cover by
opening it as shown in the illustration. Load
three R6 (UM-3) AA size batteries into the
remote control with the plus (+) and minus
(–) terminals positioned as indicated by the
diagram inside the battery compartment and
close the cover.
Remove dead batteries immediately to
avoid corrosion damage.
To avoid potential corrosion damage,
never mix old batteries with new ones.
The manganese batteries supplied with
this unit have a service life of approxi-
mately six months, depending on fre-
quency of usage.
This unit comes equipped with R6 (UM-
3) AA manganese batteries, but we rec-
ommend that long-life alkaline batteries
LR6 (AM-3) AA be used when replacing
the batteries.
Using the remote control
The following information will help you get
optimum use from the remote control.
Place this unit away from direct bright
light, which can prevent proper operation
of the remote control.
Make sure audio rack doors do not have
coloured glass. If this unit is placed
behind such a door, this may prevent
proper remote control operation.
Using other remote controls in the same
room as this unit remote control may
cause interference.