Remote Control Codes For Onkyo Components Connected Via U; Resetting Remote Mode Buttons; Resetting The Remote Controller - Onkyo TX-SA706 Instruction Manual

Controlling Other Components—Continued
Remote Control Codes for Onkyo
Components Connected via u
Onkyo components that are connected via u are con-
trolled by pointing the remote controller at the AV
receiver/AV amplifier, not the component. This allows
you to control components that are out of view, in a rack,
for example.
1 Make sure the Onkyo component is con-
nected with an u cable and an analog
audio cable (RCA).
See page 39 for details.
2 Enter the appropriate remote control code
for the REMOTE MODE button.
• [DVD] button
31612: Onkyo DVD player with u
• [CD] button
71327: Onkyo CD player with u
• [TAPE] button
42157: Onkyo cassette recorder with u
(default)
See the previous page for how to enter remote
control codes.
3
Press the REMOTE MODE button, point
the remote controller at the AV receiver/
AV amplifier, and operate the component.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that's not connected via u, use
the following remote control codes:
• [DVD] button
30627: Onkyo DVD player without u (default)
• [CD] button
71817: Onkyo CD player without u (default)
Note:
If you connect an u-capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TAPE IN/OUT
jacks, or connect an RI Dock to the GAME/TV jacks, for
u to work properly, you must set the Input Display
accordingly (see page 48).

Resetting REMOTE MODE Buttons

You can reset a REMOTE MODE button to its default
remote control code.
1
While holding down the REMOTE
MODE button that you want to
reset, press and hold down the
[AUDIO] button until the REMOTE
MODE button lights up (about 3
seconds).
(3 seconds)
2
Within 30 seconds, press the
REMOTE MODE button again.
The REMOTE MODE button flashes
twice, indicating that the button has
been reset.
Each of the REMOTE MODE buttons
is preprogrammed with a remote con-
trol code. When a button is reset, its
preprogrammed code is restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
While holding down the
[RECEIVER] button, press and
hold down the [AUDIO] button
until the [RECEIVER] button
lights up (about 3 seconds).
(3 seconds)
2
Within 30 seconds, press the
[RECEIVER] button again.
The [RECEIVER] button flashes twice,
indicating that the remote controller
has been reset.
103