Speaker Settings - Onkyo TX-SA706 Instruction Manual

First Time Setup—Continued

Speaker Settings

If you change these settings, you must run the auto-
matic speaker setup again (see page 49).
If the impedance of any speaker is 4 ohms or more but
less than 6, set the minimum speaker impedance to 4
ohms.
If you've connected your front speakers to the FRONT
L/R and SURR BACK L/R terminal posts for bi-amping,
you must change the "Speakers Type" setting. For
hookup information, see "Bi-amping the Front Speak-
ers" on page 19.
Notes:
• When bi-amping is used, the AV receiver/AV ampli-
fier is able to drive up to 5.1 speakers in the main
room.
• Before you change these settings, turn down the vol-
ume.
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w] but-
tons to select "2. Speaker
Setup", and then press [ENTER].
The "Speaker Setup" menu appears.
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
3
Use the Up and Down [q]/[w] but-
tons to select "1. Speaker Set-
tings", and then press [ENTER].
The "Speaker Settings" menu appears.
2–1. Speaker Settings
Speakers Type
Speaker Impedance
4
5
6
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
Normal
6ohms
Use the Up and Down [q]/[w] but-
tons to select "Speakers Type",
and then use the Left and Right
[e]/[r] buttons to select:
Normal: Select this if you've con-
nected your front speakers
normally.
Bi-Amp:Select this if you've con-
nected your front speakers for
bi-amped operation.
Notes:
• Powered Zone2 cannot be used if
"Speakers Type" is set to "Bi-Amp".
• The analog multichannel input can-
not be used if "Speakers Type" is set
to "Bi-Amp".
Use the Up and Down [q]/[w] but-
tons to select "Speaker Imped-
ance", and then use the Left and
Right [e]/[r] buttons to select:
4ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
Press the [SETUP] button.
The setup menu closes.
45