Method For Copying Or Erasing The Data In Internal Memory; How To Write Data To Internal Memory - Sony DSC-T77 Service Manual

1-3. METHOD FOR COPYING OR ERASING THE DATA IN INTERNAL MEMORY

The data can be copied/erased by the operations on the HOME screen. (When erasing the data, execute formatting the internal memory.)
Note 1: When replacing the SY-207 board, erase the data in internal memory of the board before replacement.
Note 2: When replacing the SY-207 board, execute formatting and initialize the internal memory after replacement.
Method for Copying the Data in Internal Memory
Copy
Copies all images in the internal memory to a "Memory Stick Duo".
1 Insert a "Memory Stick Duo" into the camera.
2 (Manage Memory)
Tool] [Copy]
Notes
Use a fully charged battery pack. If you attempt to copy image files using a battery pack with little
remaining charge, the battery pack may run out, causing copying to fail or possibly corrupting the data.
You cannot select images to copy.
The original images in the internal memory are retained even after copying. To delete the contents of the
internal memory, remove the "Memory Stick Duo" after copying, then format the internal memory
([Format] in [Memory Tool]).
A new folder is created on the "Memory Stick Duo" and all the data will be copied to it. You cannot
choose a specific folder and copy images to it.
Method for Formatting the Internal Memory
Format
Formats the "Memory Stick Duo" or the internal memory. A commercially available "Memory
Stick Duo" is already formatted, and can be used immediately.
1 (Manage Memory)
Tool] [Format]
Notes
Note that formatting permanently erases all data including even protected images.

1-4. HOW TO WRITE DATA TO INTERNAL MEMORY

Usually, the camera has been set so as to disable the data writing from the PC to the internal memory of the camera.
This setting must be changed temporarily when the data is to be written to the internal memory such as a case after the board replacement.
To change the setting, use the write enable tool "WriteEnableTool.exe".
Data writing method
1) Connect the PC to the camera (USB mode: Mass Storage), and switch the driver to the "Sony Seus USB Driver".
2) Start the Write Enable Tool and the SeusEX.
Click the [Activate Write Enable Mode] button of the Write Enable Tool.
3)
4) Upon completion of the setting change, the following message will be displayed.
5) Return the driver to the original one, and connect the PC to the camera (USB mode: Mass Storage).
6) Write the data read out into the PC to the internal memory of the camera.
7) Disconnect the PC from the camera, and turn off the camera.
Note: By turning off the camera, the write enable setting is reset.
DSC-T77_L2
[Memory
[OK]
[Memory
[OK]
1-2
ENGLISH JAPANESE
ENGLISH JAPANESE