Table of Contents
Advertisement
Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by relocating
the clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck lift pedal with your foot and raise the
mower deck to the transport position (also the 140 mm
(5-1/2 inch) cutting height position)
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired and, insert the pin
26).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
Figure 26
1. Deck lift pedal
2. Cut of height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers as shown in
Figure 28
to match the closest height-of-cut position.
(Figure
26).
(Figure
26).
(Figure
3. Transport lock
Figure 27
and
1
2
3
1. Flange Nut
2. Anti-scalp roller
1
g024243
1. Bolt
2. Bushing
Adjusting the Skid(s)
Mount the skids in the lower position when operating in
height of cuts higher than 64 mm (2-1/2 inches) and in the
higher position when operating in height of cuts lower than
64 mm (2-1/2 inches).
Note: When the skids become worn, switch the skid to the
opposite sides of the mower, flipping them over. This will
allow you to use the skids longer before replacing them.
1. Disengage the PTO and set the parking brake.
24
4
g024242
Figure 27
3. Bushing
4. Bolt
2
3
Figure 28
3. Anti-scalp roller
4. Flange Nut
4
Advertisement
Table of Contents
