Table of Contents
Advertisement
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Remove the carriage bolts and nuts from each skid
(Figure
29).
1
g024244
1. Carriage bolt
2. Skid
4. Move each skid to the desired position and secure them
with the carriage bolts and nuts.
Note: Only use the top or center sets of holes to
adjust the skids. The bottom holes are used when
switching sides on the mower deck, at which time they
become the top holes on the other side of the mower.
5. To prevent damaging the skid, torque the carriage bolts
and nuts for each skid to 12.4 to 14.7 N-m (110 to 130
in-lb).
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
To adjust, move the lever sideways to unlock seat
g019754
2
3
Figure 29
3. Nut
(Figure
Figure 30
Unlatching the Seat
Note: Certain models will have a fixed seat and cannot be
rotated up.
1. Seat latch
Changing the Seat Suspension
The seat is adjustable to provide a smooth and comfortable
ride. Position the seat where you are most comfortable.
To adjust it, turn the knob in front either direction to provide
the best comfort
1
1. Seat suspension knob
30).
Using the Drive-Wheel Release
Valves
WARNING
Hands may become entangled in the rotating drive
components below the engine deck, which could
result in serious injury.
Stop the engine, remove the key, and allow all
moving parts to stop before accessing the drive
wheel release valves.
25
Figure 31
2. Seat
(Figure
32).
g019768
Figure 32
g019755
Advertisement
Table of Contents
