Setup; Installing The Drive Shaft To An Optional Mower Deck Or Qas - Toro 31223 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Material
1
Installing the Drive Shaft to an
Optional Mower Deck or QAS
Parts needed for this procedure:
1 Driveshaft
4 Screw, 5/16 x 1–3/4 inch
4
Lock nut, 5/16 inch
2 Roll pin, 3/16 x 1–1/2 inch
Procedure
Note: PTO drive shaft installation is easier if the machine is
positioned on a hoist.
1. Park machine on a level surface, stop engine, engage
parking brake and remove key from the ignition switch.
Description
Driveshaft
Screw, 5/16 x 1–3/4 inch
Lock nut, 5/16 inch
Roll pin, 3/16 x 1–1/2 inch
Retainer pin
Grease fitting
Washer head screw, 5/16 x 7/8 inch
No parts required
No parts required
No parts required
Qty.
1
4
4
2
2
2
2
–
–
–
Qty.
1 Read before operating the machine
1
Read before operating the machine
1 Use reference part numbers
1 View the video before operating the machine
WARNING
Do not start the engine and engage the
PTO switch when the PTO drive shaft is
disconnected from the cutting deck. If the
engine is started and the PTO shaft is allowed
to rotate, serious personal injury and machine
damage could result. Before the PTO drive
shaft is disconnected from the cutting deck,
disconnect PTO solenoid coil connector
from wire harness to prevent unintentional
engagement of the PTO clutch.
2. To prevent the unintentional engagement of the PTO
clutch, disconnect the wire harness electrical connector
from the PTO solenoid valve coil connector
11
Use
Install the drive shaft to a optional deck
or QAS
Use to install optional mower deck
Adjust the ROPS
Check the tire pressure.
Check the hydraulic fluid, engine oil,
and coolant levels.
Use
(Figure 3).