Philips D630 Extended User Documentation page 50

The handset on the charger does not charge
or the battery discharges too fast.
• Make sure the batteries are inserted
correctly.
•
Make sure the handset is placed properly
on the charger. If the docking tone is
turned on, you can hear the docking
tone when you place the handset on the
charging cradle.
• The charging contacts are dirty. Disconnect
the power supply first and clean the
contacts with a damp cloth.
•
The battery is not fully recharged. Leave
the handset on the charging cradle for at
least 8 hours or until the battery icon on
the handset stops scrolling and indicates
full bar.
•
The batteries are old or defective.
Purchase and replace with new
rechargeable batteries with the same
specifications.
No display.
•
Make sure the batteries are charged.
•
Make sure there is power and the phone is
connected.
Bad audio (crackles, echo, etc.).
• The handset is nearly out of range. Move it
closer to the base station.
•
The phone receives interference from the
nearby electrical appliances. Move the base
station away from them.
• The phone is at a location with thick walls.
Move the base away from them.
• The phone receives interference from the
DSL (digital subscriber line) connection.
Install a DSL filter to prevent the noise.
Contact your service provider for the DSL
filter.
The handset does not ring.
•
Make sure the handset ringtone is turned
on.
•
Make sure the handset is registered to the
base station.
The caller ID does not display.
•
The service is not activated. Check with
your service provider.
48 EN
•
The caller's information is withheld or
unavailable.
Note
•
If the above solutions do not help, disconnect the
power supply from both the handset and base station.
Try again after 1 minute.