Register Additional Handsets - Philips D630 Extended User Documentation

2
Press / to select
[Select].
3
Select [Auto clock], then press [OK] to
confirm.
4
Select [On]/[Off], then press [OK] to
confirm.
» The setting is saved. .

Register additional handsets

You can register additional handsets to the base
station. The base station can register up to 4
handsets.
Auto registration
Extra handsets of the same model can be auto-
registered. Place the unregistered handset on
the base station.
» The handset detects the base station
and registers automatically.
» Registration is complete in less
than two minutes. The base station
automatically assigns a handset number
to the handset.
Manual registration/Pairing
If auto registration fails or if you register a
handset of a different model, register your
handset manually to the base station.
1
If the handset is in [Unregistered] status,
go to step 4. If the handset is in [searching]
and [Unavailable] status, press [Menu] >
/ to select , then press [Select].
2
Select [Register], then press [OK] to
confirm.
3
Press and hold
10 seconds.
42 EN
, then press
on the base station for
Note
•
For models with an answering machine, you hear a
confirmation beep indicating that the base is now in
registration mode.
4
Enter the system PIN/passcode. Press
[Clear] to make corrections.
5
Press [OK] to confirm the PIN/passcode.
» Registration is complete in less than 2
minutes.
Note
•
If the PIN/passcode is incorrect or no base is found
within a certain period, a notification message will be
displayed on your handset.
•
The preset PIN/passcode is 0000. No change can be
made on it.
Unregister handsets
If two handsets share the same base station, you
can unregister a handset with another handset.
1
Select [Menu].
2
Press / to select
[Select].
3
Select [Unregister], then press [OK] to
confirm.
4
Select the handset to be unregistered.
5
Press [OK] to confirm.
» The handset is unregistered.
Note
•
A handset cannot unregister itself.
Restore default settings
You can reset your phone settings to the
original factory settings.
, then press