Rear Panel Facilities And Connections - Integra RDA-7.1 Instruction Manual

Rear panel facilities and connections

Caution
• Do not connect the Power cord until you have finished all other connections.
• Read the instructions that came with the other components you are connecting.
• Do not make connections to input or output jacks while the RDA-7.1 is turned on (Power
• Always turn the volume of the AV controller down before turning on the RDA-7.1.
Precaution for connection
This unit comprises 7 independent power amplifiers, each
being capable of reproducing the same quality sound
through its channel. Note that you should connect an input
source and a speaker to each channel in use. For channels
that are not in use, we recommend that you do not connect
any input source or speaker.
Balanced Input (XLR terminal)
Connect AV controllers or pre amplifiers with balanced
outputs for high-quality sound.
2 1
3
Connector ground terminal: Chassis grounded
The pin assignments for this terminal are given above. This
pin assignment conforms to the standard adopted by the
Audio Engineering Society. Refer to the instruction manual
supplied with the AV controller and verify that its output
terminal is compatible with the pin assignments for this
terminal. If it does not, wire it so that the output pins
connect with the proper input pins.
Input terminal
1. Connecting the input terminal
Match the pins and insert the terminal until you hear a
"click." Ensure that it is secure by gently pulling it.
10
SURROUND BACK SURROUND
RIGHT
RIGHT
INPUT INPUT
SELECT SELECT
OUTPUT OUTPUT OUTPUT
2. non-inverting (+)
1. GND
3. inverting (–)
FRONT FRONT
RIGHT CENTER LEFT
INPUT INPUT
SELECT SELECT
OUTPUT OUTPUT
SPEAKER IMPEDANCE
4 OHMS MIN. PER EACH
SPEAKER TERMINAL
FUSE AC INLET
2. Disconnecting the input terminal
Pull out the connection cord while holding down the lever.
Note:
• When using this balanced connection for a specific
channel between the AV controller and RDA-7.1, set
the INPUT SELECT switch to the XLR input side to
select balanced input. Next, use balanced cables and
connect the balanced output from the AV controller to
the corresponding balanced input on the RDA-7.1.
• Do not connect anything to the RCA-type audio input
jack.
Unbalanced Input (single end RCA
input)
Connect AV controllers or pre amplifiers with single-
ended outputs for high-quality sound.
Note:
• When using this single-ended connection for a
specific channel between the AV controller and
RDA-7.1, set the INPUT SELECT switch to the RCA
input side to select unbalanced input. Next, use RCA
cables and connect the single-ended output from the
AV controller to the corresponding single-ended
input on the RDA-7.1.
• Do not connect anything to the balanced input jack.
INPUT SELECT
This switch is located between the balanced input and
single-ended RCA input for each channel. Use this switch
to select the input type for its channel.
SURROUND SURROUND BACK
LEFT LEFT
INPUT INPUT INPUT
SELECT SELECT SELECT
OUTPUT OUTPUT
12V TRIGGER
SEVEN CHANNEL AMPLIFIER
MODEL NO.
IN OUT
Push
/
on).
RDA-7.1