Rear Panel Facilities And Connections - Integra ADM-30.1 Instruction Manual

Rear panel facilities and connections

Caution:
- Be sure to always refer to the instructions that came
with the component that you are connecting.
- Do not plug in the power cord until all connections
have been made.
- Do not make connections to input or output jacks
while the ADM-30.1 is turned on.
- Always turn the volume of the control amplifier or
preamplifier down before turning on the ADM-30.1.
- For input and output jacks, red connectors (marked
R) are used for the right channel and white connec-
tors (marked L) are used for the left channel.
INPUT/OUTPUT
These are the analog audio inputs and outputs. Use
an RCA-type audio connection cable to connect
the output jacks of the device to the INPUT jacks
on the ADM-30.1. When connecting a control
amplifier or preamplifier, connect the PRE OUT
jacks to the INPUT jacks.
If you connect the OUTPUT jacks of the ADM-
30.1 to the INPUT jacks of another ADM-30.1, the
signal input at the INPUT jacks of the ADM-30.1
is also output from the OUTPUT jacks (Input/
Output Link Function).
If you set the AUDIO SENSE switch to ON, the
amplifier circuit of the connected ADM-30.1 turns
on automatically when an audio signal is supplied
to the INPUT jacks (Amplifier Circuit Auto On/
Off Function).
INPUT LEVEL
Turn this INPUT LEVEL control to adjust the
input level of the signal from the INPUT jacks.
Normally, set to MAX.
Notes
When a CD player is connected to the ADM-30.1, be sure to
adjust the INPUT LEVEL control.
6
- Insert all plugs and connectors securely. Improper
connections can result in noise, poor performance, or
damage to the equipment.
Improper connection
Inserted completely
- Do not bind audio connection cables with power
cords and speaker cables. Doing so may adversely
affect the sound quality.
AUDIO SENSE LEVEL
If you activate/deactivate the amplifier circuit by
turning on/off the device connected to the INPUT
jacks, use this AUDIO SENSE LEVEL to set the
sensitivity of the input signal (-6dB to 0dB). The
level is factory set to 0dB.
AUDIO SENSE
With this switch set to ON, the amplifier circuit
will be activated/deactivated when the device con-
nected to the INPUT jacks is turned on/off.
The sensitivity of the input signal from the device
can be set with the AUDIO SENSE LEVEL.
Notes
The Power switch of the ADM-30.1 needs to be set to On in
advance. If no audio signal is received for about 10 minutes, the
ADM-30.1 enters the Ready state and the Power indicator lights
red.
12V TRIGGER
With this switch set to ON, the amplifier circuit
will be activated/deactivated when the device
connected to the 12V TRIGGER IN jack is turned
on/off.
Notes
The Power switch of the ADM-30.1 needs to be set to On in
advance.