Briggs & Stratton Intek Snow 120000 Operating And Maintenance Instructions Manual page 12

STARTING AND STOPPING
ELECTRIC STARTER (if equipped)
Industrial PlusE Snow MODEL 90000
To Start Engine:
[1.] Check oil level.
[2.] Move choke lever to start position.
[3.] Depress primer (if equipped).
Note: If temperature is 15° or higher push
primer two times, if below 15° push primer
four times.
[4.] Turn key to start (if equipped).
[5.] Depress starter button.
CAUTION:
To prolong starter life, use short starting cycles
(5 seconds maximum, then wait one minute).
Follow equipment manufacturer's recommenda-
tions for charging battery.
[6.] Allow engine to warm up several minutes, slowly
adjusting choke. Wait until engine runs smoothly
before each choke adjustment.
To Stop Engine:
[1.] Turn key to OFF position (if equipped).
Typical Key Switch
Typical Choke Lever
Typical Key Switch
12
Typical Primer
Typical Electric Start
Button