Check Hydraulic System Fluid - Toro 04380 Operator's Manual

Before Operating
DAMAGE COULD RESULT.
1. Clean the area around the fuel tank cap.
1. Fuel tank cap
2. Remove the fuel tank cap.
3. Fill the tank to about one inch below top of the tank,
(bottom of the filler neck). DO NOT OVERFILL.
Then install the cap.
CHECK THE COOLING SYSTEM
(Fig. 4–5)
If the engine has been running, pressurized hot coolant
can escape and cause burns.
Capacity of the cooling system is 3.4 L.
Clean debris off the radiator screen and the radiator daily
(Fig. 4)—hourly if conditions are extremely dusty and
dirty; refer to Cleaning the Radiator and Screen.
1. Radiator screen
2. Radiator
12
Figure 3
CAUTION
Figure 4
The cooling system is filled with a 50/50 solution of
water and permanent ethylene glycol anti-freeze. Check
the level of coolant at beginning of each day before
starting the engine.
1. Park the machine on a level surface.
2. Check coolant level. Coolant should be between
the lines on reserve tank, when the engine is cold.
1. Reserve tank
2. Radiator cap
3. If coolant is low, remove the reserve tank cap and
add a 50/50 mixture of water and permanent
ethylene glycol anti-freeze. DO NOT OVERFILL.
4. Install the reserve tank cap.
CHECK THE HYDRAULIC SYSTEM
FLUID
The hydraulic system is designed to operate on anti-wear
hydraulic fluid. The machine's reservoir is filled at the
factory with 30.8 L of Mobil 424 hydraulic fluid. Check
the level of hydraulic fluid before the engine is first
started and daily thereafter.
Group 1 Hydraulic Fluid (Recommended for ambient
temperatures consistently below 100° F)
Mobil
Amoc
International Harvester
Texaco
Boron Oil
BP Oil
Chevron
Conoco
Figure 5
Mobil Fluid 424
Amoco 1000
Eldoran UTH
BP HYD TF
Tractor Hydraulic fluid
Power-Tran 3
Hy-Tran
TDH