Toro 74722 Operator's Manual page 39

3. Measure from the tip of the blade to the flat surface
(Figure 45).
1
2
Figure 45
1. Blade (in position for measuring)
2. Level surface
3. Measured distance between blade and the surface (A)
4. Rotate the same blade 180 degrees so that the opposing
cutting edge is now in the same position
1
Figure 46
1. Blade (side previously measured)
2. Measurement (position used previously)
3. Opposing side of blade being moved into measurement
position
5. Measure from the tip of the blade to the flat surface
(Figure 47).
Note: The variance should be no more than 3 mm
(1/8 inch).
G014973
3
(Figure
3
2
G014974
1. Opposite blade edge (in position for measuring)
2. Level surface
3. Second measured distance between blade and surface (B)
A. If the difference between A and B is greater than
3 mm (1/8 inch), replace the blade with a new
blade; refer to
(page
46).
Note: If you replace a bent blade with a new
blade and the dimension obtained continues to
exceed 3 mm (1/8 inch), the blade spindle could
be bent. Contact an Authorized Toro Dealer for
service.
B. If the variance is within constraints, move to the
next blade.
6. Repeat steps
39
1
3
2
Figure 47
(page ) and Installing the Blades
40).
1 through 5 for each blade.
G014973